Discount wholesale Regenerative Desiccant Air Dryer - 2.4 M3/Min Environmental Aluminum Plate Exchange Refrigerated Air Dryer TR-02 for Air Compressor – Tianer

Product Paramters

Basic Info.

TR Series Condition

TR Series Refrigerated Air Dryer

High Efficiency
The integrated heat exchanger is equipped with guide fins to make the compressed air evenly exchange heat inside, and the built-in steam-water separation device is equipped with a stainless steel filter to make the water separation will be more thoroughly.

The model is flexible and changeable
The plate heat exchanger can be assembled in a modular fashion, that is, it can be combined into the required processing capacity in a 1+1=2 manner, which makes the design of the whole machine flexible and changeable, and can more effectively control the raw material inventory.

High heat exchange efficiency
The flow channel of the plate heat exchanger is small, the plate fins are waveforms, and the cross-section changes are complicated. A small plate can obtain a larger heat exchange area, and the flow direction and flow rate of the fluid are constantly changed, which increases the flow rate of the fluid. Disturbance, so it can reach turbulent flow at a very small flow rate. In the shell-and-tube heat exchanger, the two fluids flow in the tube side and the shell side respectively. Generally, the flow is cross-flow, and the logarithmic average temperature difference correction coefficient is small.

There is no dead angle of heat exchange, basically achieving 100% heat exchange
Due to its unique mechanism, the plate heat exchanger makes the heat exchange medium fully contact the plate surface without heat exchange dead angles, no drain holes, and no air leakage. Therefore, compressed air can achieve 100% heat exchange. Ensure the stability of the dew point of the finished product.

Good corrosion resistance
The plate heat exchanger is made of aluminum alloy or stainless steel structure, which has good corrosion resistance and can also avoid secondary pollution of compressed air. Therefore, it can be adapted to various special occasions, including marine ships, with corrosive gases The chemical industry, as well as the more stringent food and pharmaceutical industries.

Matters Needing Attention

The use of cold drying machine should pay attention to the following matters:

(1) the flow pressure of compressed air, temperature should be allowed within the scope of the nameplate;

(2) The installation site should be ventilated, less dust, there is enough heat dissipation and maintenance space around the machine and can not be installed outdoors, to avoid rain and direct sunlight;

(3) Cold drying machine is generally allowed without foundation installation, but the ground must be leveled;

(4)  Should be as close to the user point as possible to avoid too long pipeline;

(5) There should be no detectable corrosive gas in the surrounding environment, especially pay attention to not coexist with ammonia refrigeration equipment in the same room;

(6) The filter precision of the pre-filter of the cold drying machine should be appropriate, too high precision is not necessary for the cold drying machine;

(7) The cooling water inlet and outlet pipe should be set independently, especially the outlet pipe can not be shared with other water cooling equipment, to avoid pressure difference caused by blocked drainage;

(8)  at any time to keep the automatic drainer drainage smooth;

(9) Do not start the cold drying machine continuously;

(10)  cold drying machine actual processing of compressed air parameters, especially the inlet temperature, working pressure and rating does not conform, according to the sample provided by the “correction coefficient” for correction, in order to avoid overload operation.

Product Display