Factory Cheap Hot High Pressure Air Dryer Machine - Match up compressed refrigetated air dryer TR-10 for Compressor – Tianer

Product Paramters

TR Series Condition

TR Series Refrigerated Air Dryer

Energy saving:
The aluminum alloy three-in-one heat exchanger design minimizes the process loss of the cooling capacity and improves the recycling of the cooling capacity. Under the same processing capacity, the total input power of this model is reduced by 15-50%

High Efficiency:
The integrated heat exchanger is equipped with guide fins to make the compressed air evenly exchange heat inside, and the built-in steam-water separation device is equipped with a stainless steel filter to make the water separation will be more thoroughly.

Intelligent：
Multi-channel temperature and pressure monitoring, real-time display of dew point temperature, automatic recording of accumulated running time, self-diagnosis function, display of corresponding alarm codes, and automatic protection of equipment

Environmental protection:
In response to the International Montreal Agreement, this series of models all use R134a and R410a environmentally friendly refrigerants, which will cause zero damage to the atmosphere and meet the needs of the international market.

Good corrosion resistance
The plate heat exchanger is made of aluminum alloy or stainless steel structure, which has good corrosion resistance and can also avoid secondary pollution of compressed air. Therefore, it can be adapted to various special occasions, including marine ships, with corrosive gases The chemical industry, as well as the more stringent food and pharmaceutical industries.

Attention

1. The flow pressure and temperature of compressed air should be within the allowable range of the nameplate;

2. The installation site should be ventilated, less dust, there is enough heat dissipation and maintenance space around the machine and can not be installed outdoors, to avoid rain and direct sunlight;

3. Cold drying machine is generally allowed without foundation installation, but the ground must be leveled;

4. Should be as close to the user point as possible to avoid too long pipeline;

5. There should be no detectable corrosive gas in the surrounding environment, especially pay attention to not coexist with ammonia refrigeration equipment in the same room;

6. The filter precision of the pre-filter of the cold drying machine should be appropriate, too high precision is not necessary for the cold drying machine;

7. The cooling water inlet and outlet pipe should be set independently, especially the outlet pipe can not be shared with other water cooling equipment, to avoid pressure difference caused by blocked drainage;

8. At any time to keep the automatic drainer drainage smooth;

9. Do not start the cold drying machine continuously;

10. Cold drying machine actual processing of compressed air parameters, especially the inlet temperature, working pressure and rating does not conform, according to the sample provided by the “correction coefficient” for correction, in order to avoid overload operation.

Product Display